Operational conditions
| Operating altitude |
-100 - 4000 m |
Additionally
| Transfer rate (Mbps) |
10000 Mbit/s |
| Wireless technologies |
Wired |
1-Channel, LC, SF, Tx 1471nm, Rx 1491nm, 12 oz
iConverter Single-Fiber CWDM/AD
- 1-Channel Optical Add and Drop Multiplexers modules
- Add and Drop functions in both directions
Features
- Protocol and rate transparent for applications up to 10Gbps
- Minimal and uniform optical loss facilitates easy network planning
- Industry standard LC connectors
- Seamless integration with other iConverter media converters and chassis for multi-service platforms
- Passive device that can be installed in a powered chassis for managed applications
- Manageable via SNMPv1/v2c/v3, Telnet or serial console port
- One (1) Year Warranty and Free 24/7 Technical Support
iConverter Single-Fiber Course Wave Division Multiplexing (CWDM) modules provide a flexible and cost effective solution for increasing fiber capacity over single fiber networks. CWDM over single-fiber increases network bandwidth capacity by enabling multiple wavelengths, or data channels that carry independent services over existing fiber infrastructure. Up to sixteen separate wavelengths can be transported on a single-fiber link with iConverter Single-Fiber CWDM modules.
iConverter 1-Channel Single-Fiber CWDM/AD modules are Course Wave Division Multiplexing (CWDM) Optical Add and Drop Multiplexers (OADM). The CWDM/AD modules add (multiplex) and drop (de-multiplex) one channel on both directions of a CWDM single-fiber route. Nine standard models of the 1-Channel Single-Fiber CWDM/AD modules are available.
iConverter CWDM/AD modules add new access points anywhere on a single-fiber CWDM network, without impacting the remaining channels traversing the network. Access points can be added to linear, bus, and ring networks, where the dual-direction ring design provides redundant protected architecture.
The small and compact size of the iConverter CWDM/X and CWDM/AD modules yields one of the highest port densities in the industry. A 2U high 19-module iConverter chassis populated with modules can yield up to 120 wavelengths of capacity.
iConverter CWDM/X modules are passive devices that require no external power. They can also be installed in an iConverter powered chassis with a management module and be managed using Omnitron’s NetOutlook network management software, third-party SNMP software, Telnet or a serial console port.
The modules can be installed in any iConverter chassis equipped with other iConverter media converters and transponders to provide a multi-service platform capable of delivering Ethernet, TDM, SONET and other services across a CWDM fiber common link.
