Features
| Front to back ratio |
24 dB |
| Downtilt |
25 ° |
| Mounting pipe |
15 - 86 mm |
| Antenna connector type |
TwistPort |
| Polarization |
Dual polarization |
| Antenna type |
Directional antenna |
| Survival wind speed |
160 km/h |
Performance
| Vertical beam width |
12 ° |
| Horizontal beam width |
12 ° |
| Antenna gain level (max) |
24 dBi |
| Frequency band |
5.1 - 6 GHz |
Parabolic Dish, IP65, 24 dBi, 15-86 mm, 2.3 kg
UltraDish TP Antennas
Parabolic dish antennas with a TwistPort connector and an innovative mount.
High Gain Directional Antennas
UltraDish TP Antennas are high-gain directional parabolic antennas with a lossless TwistPort connector. The antennas are highly directional and have suppressed sidelobes for ultimate performance.
TwistPort Connector
TwistPort connector is a quick-locking virtually lossless waveguide port that connects the radio with the antenna. The TwistPort connector is our design and sets a new standard for outdoor wireless equipment in terms of performance, scalability, ease of use and deployment simplicity.
Virtually Lossless
TwistPort connectors are virtually lossless: there are no coaxial RF connectors or RF cables that cause signal loss. In comparison to widely used coaxial cables and connectors, the loss on TwistPort is almost unmeasurable.
The New Definition Of Easy
TwistPort is the new definition of “easy”. By integrating the mechanical and the RF connection into the same structure, the connection of the radio to the antenna is brilliantly simple - “twist and lock” - and can be done with one hand!
Performance
Suppressed sidelobe radiation reduces interferences and enables installation in areas with high noise levels. The gain of UltraDish TP Antennas is achieved by focusing the signal delivered via the TwistPort waveguide connector. UltraDish TP 380 provides a 24dBi gain and an 8° (-3dB) beamwidth.
Innovative Mounting System
UltraDish TP Antennas features a new innovative mounting system. The mount is separated from the antenna which makes the antenna installation and adjustment easy and quick.
Step 1: Bracket Installation
First install the bracket on the pole. Two sets of pole screws for different pole diameters are included.
The pole bracket is reversible: it can be mounted on the left or the right side of the antenna.
Step 2: Antenna Adjustment
Simply slide the antenna in the bracket and adjust the elevation and the azimuth. Tighten the screws to finish the installation.
Only one tool is needed for the entire installation.
Cross-Platform Compatibility
UltraDish TP Antennas can be used with any radio with a TwistPort interface or with a variety of third-party radios connected through a TwistPort Adaptor.
