Transition Networks CCSCF3029-110 Internal 51.8Mbit/s 1310nm Single-mode network media converter

2x BNC to 1310nm TX/1550nm RX, single fiber, single mode, SC The DS3 – T3/E3 & STS-1 copper to fiber network interface device (NID) provides a solution for those users that need to extend DS3 connections over fiber.

The DS3 – T3/Es & STS-1 supports Small Form Pluggable (SFP) transceivers to support a variety of fiber types, distances and wavelengths to provide maximum flexibility across a variety of network topologies. The use of Coarse Wave Division Multiplexing (CWDM) SFPs can be utilized to further increase the bandwidth capacity of the fiber infrastructure.

The DS3 – T3/E3 & STS-1 NID must be used in pairs. A typical installation will include a chassis card installed in the Point System™ locally and a stand-alone device installed at the remote location.

- AIS (Alarm Indication Signal)
- Coax Line Build Out
- Switch selectable for DS3/T3 or E3
- Loopback – Coax and Fiber
- LEDs for immediate visual status
- Supports dual or single fiber
- Supports multimode and single mode fiber at a variety of distances
- Supports CWDM SFPs
- SNMP management when used with Point System™ chassis and management module
- Field Upgradeable Firmware when used with Point System™ Chassis and management module