Transition Networks CSDTF1012-120 Internal 1310nm Single-mode network media converter

T1/E1 Copper to Fiber, Point System Slide-In-Module Media Converter, Twisted Pair (RJ-48) [1.5 km/0.9 mi.], 1310nm single mode (ST) [8 km/5 mi.] The Remotely Managed T1/E1 copper to fiber media converter will provide a solution for users who desire to extend their T1 or E1 circuits over fiber and remotely manage them "in-band" from admin locations.

- Remote unit "in-band" management
- Local or Remote Loop-backs on copper or fiber in software mode
- Loopback switch facilitates local installation
- Converts the copper ports on T1/E1 devices, such as a PBX or T1/E1 Router, to multimode or single mode fiber
- Extends distances 2,000 meters over multimode fiber or 80,000 meters over single mode fiber.
- Switch selectable RJ-48 connectors for T1 or E1
- Jitter attenuators optimize Bit Error Rate (BER) performance
- Network debug procedures make BER testing more convenient
- Built-in troubleshooting with the addition of a selectable TAOS (Transmit All Ones) switch on the fiber and copper interfaces allows the network engineer to test all T1/E1 equipment on that network segment and ensure the network link.
- Dry relay contacts enable the media converter to be tied into a separate alarm circuit commonly found in a T1/E1 twisted pair environment. Contacts will be activated on loss of power or loss of fiber link.
- An LED provides Alarm Indication Signal (AIS)
- Can be used with fractional T1/E1 circuits.