Performance
| Link budget |
11.00 dB |
| Sensitivity |
-30 dBmW |
| Tx power (min) |
-19 dBmW |
| Maximum transfer distance |
2000 m |
| Fiber mode structure |
Multi-mode |
| Tx power (max) |
-14 dBmW |
| Wavelength |
1300 nm |
Operational conditions
| Operating altitude |
0 - 3000 m |
Additionally
| Ethernet LAN (RJ-45) ports quantity |
1 |
| Wireless technologies |
Wired |
| Transfer rate (Mbps) |
100 Mbit/s |
Fast Ethernet Media Converter, 100BASE-TX (RJ-45) [100 m/328 ft.], 100BASE-FX 1300nm multimode (ST) [2 km/1.2 mi.]
With the Remotely Managed Fast Ethernet media converter solution, service providers can now monitor and manage the entire optical link from the Central Office (CO) to the Customer Premise Equipment (CPE).
When used in conjunction with a managed Point System™ chassis card, CRMFE10xx-200, this stand-alone unit can be managed remotely. This Fast Ethernet media converter provides a fully-managed conversion between 100BASE-TX and 100BASE-FX signals at Customer Premises.
- Loopback
This feature puts a converter in a special mode that enables the device to loop back the signal from the RX port to the TX port on either media for testing and troubleshooting purposes.
- Bandwidth utilization report
Allows service providers to gather information about customers' bandwidth utilization. This information, in conjunction with Transition Networks' Focal Point 2 Collector Application, can automatically be recorded in the database and used to support service level agreements (SLAs) or reported back to the customer.
- Auto-Negotiation (802.3u)
Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.
- AutoCross™
Automatically detects and configures the twisted pair port on the converter to the correct MDI or MDI-X configuration.
- Link Pass Through
Link Pass Through is a troubleshooting feature that allows the media converter to monitor both the fiber and copper RX ports for loss of signal.
- Far End Fault (FEF)
A troubleshooting feature that is generally used in conjunction with Link Pass Through to notify both end devices of a loss of link.
- Link Restoration
The converters will automatically re-establish link when connected to two 10/100 auto-negotiating switches if link is lost. With other manufacturers' converters the user must intervene to re-establish link.
- Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed.
