Ports & interfaces
DC-in jack |
Y |
Fiber ports quantity |
1 |
Performance
Wavelength |
1300 nm |
Sensitivity |
-33.5 dBmW |
Tx power (min) |
-19 dBmW |
Maximum transfer distance |
2000 m |
Tx power (max) |
-14 dBmW |
Operational conditions
Operating altitude |
0 - 3000 m |
Additionally
Wireless technologies |
Wired |
Twisted Pair (RJ-48) [1.5 km/0.9 mi.] to 1300nm multimode (MT-RJ) [2 km/1.2 mi.], North America
<b>Remote Management with a Stand-Alone Device</b>
When used in conjunction with a managed Point System™ chassis, this stand-alone unit can be managed remotely. The Remotely Managed T1/E1 copper to fiber media converter will provide a solution for users who desire to extend their T1/E1 or PRI circuits over fiber and remotely manage them "in-band" from admin locations.
- Remote unit "in-band" management
- Local or Remote Loop-backs on copper or fiber in software mode
- Loopback switch facilitates local installation
- Converts the copper ports on T1/E1 devices, such as a PBX or T1/E1 Router, to multimode or single mode fiber.
- Extends distances 2,000 meters over multimode fiber or 80,000 meters over single mode fiber.
- Switch selectable RJ-48 connectors for T1 or E1.
- Jitter attenuators optimize Bit Error Rate (BER) performance.
- Network debug procedures make BER testing more convenient.
- Built-in troubleshooting with the addition of a selectable TAOS (Transmit All Ones) switch on the fiber and copper interfaces allows the network engineer to test all T1/E1 equipment on that network segment and ensure the network link.
- Dry relay contacts enable the media converter to be tied into a separate alarm circuit commonly found in a T1/E1 twisted pair environment. Contacts will be activated on loss of power or loss of fiber link.
- An LED provides Alarm Indication Signal (AIS).
- Can be used with fractional T1/E1 circuits.
- Report converter status:
Copper & Fiber Link Status
Hardware switch settings: LBO, AIS Copper, AIS Fiber, HW/SW
AIS detected Copper & Fiber
Model Number
Copper & Fiber Connector
- Remote commands:
Loop-back Copper & Fiber
AIS transmitted on Fiber on loss of Copper link
AIS transmitted on Copper on loss of Fiber link
- Extend PRI over fiber