Audio
Audio output channels |
2.0 channels |
RMS power output per channel (8 Ohm) |
30 W |
Total Harmonic Distortion (THD) |
2% |
Input sensitivity |
500 mV |
Frequency range |
50 - 18000 Hz |
Output impedance |
8 Ω |
Signal-to-Noise Ratio (SNR) |
75 dB |
Input impedance |
47000 Ω |
Technical details
Speaker type |
2-way |
Handheld remote control |
Y |
Remote control type |
IR |
Purpose |
Home |
Additionally
Wireless technologies |
Wired |
AV-1700 2 x 30w Digital Amplifier & SP-1600 Pair 2-Way Wall Loudspeakers
AV-1700:
The Techaudio AV-1700 is compact, flexible, easy to use and is extremely efficient. Use as a standalone mixer and amp, or as a mixer which outputs to a bigger amp or powered loudspeakers.
4 x Stereo Inputs
4 stereo inputs accept input from a variety of sources such as computers (via the headphone jack), tablets or phones. 3 of the inputs are via 2-phono (RCA) connectors on the rear panel. Input 4 is via a 3.5mm minijack connector, and is duplicated on the front and rear panels for easy access.
Line Output
A line-level pre-output on the rear panel bypasses the internal amplifier. It would connect to a larger amplifier or powered loudspeakers. It is post-mix, which means any volume adjustment made on the AV-1700 affects the output level.
Microphone Input
It uses a professional XLR connector and the input is balanced to eliminate electro-magnetic noise induced on long cables. The microphone input has “Phantom Power” – a voltage which is required by condenser-type microphones such as lectern microphones.
Remote Control
The IR remote control gives the user bass and treble adjustment and direct input selection. The AV-1700 can be controlled by a control device such as Techconnect Control via IR or RS-232.
Simple Interface
The clear simple interface offers the user just two dials.
Auto-Standby
If the amplifier senses no input it will automatically go into standby mode. As soon as you press play on your source device it will automatically switch on again.
Mounting Options
Optional mounting hardware is available which allows attachment to a wall, projector ceiling pole, or rack.
SP-1600:
Vision’s SP-1600 loudspeakers are easier to install than any other speaker in its class, with superb sound quality and a robust chassis. They are powerful, professional, and acoustically optimised for the Vision range of amplifiers.
Lower Bass Response
A structurally rigid MDF chassis and a specially tuned bass reflex port have extended the bass response down, resulting in more natural music reproduction.
Rugged Grille
Refreshed industrial design makes the SP-1600 attractive and robust. The thick metal grille protects the drivers from physical interference.
Tough Finish
The finish withstands the rigors of the professional use.
AV Applications
AV presentation environments demand a wide dispersion so everyone in the audience can hear clearly, so the SP-1600 uses ferro-fluid cooled dome tweeters.
Unique brackets
Vision’s unique brackets allow very fast installation and end users can even swap out the loudspeakers with no specialist knowledge or tools.
1. Fit the bracket to the wall.
2. Terminate cables to the bracket.
3. Clip loudspeaker into place. A locking mechanism secures the chassis in place.
Close-fit bracket
The slim profile brackets allow a very close fit to the walls of less than 20mm.