Loudspeakers
| Woofer |
Y |
| Tweeter diameter |
1 " |
| Woofer diameter (imperial) |
3.5 " |
| Number of speakers |
2 |
| Recommended usage |
universal |
| Number of woofer drivers |
1 |
| Tweeter |
Y |
| Number of tweeter drivers |
1 |
Audio
| Impedance |
8 Ω |
| Sensitivity |
86 dB |
| Frequency range |
90 - 20000 Hz |
Power
| Power source type |
Not supported |
Additionally
| Wireless technologies |
Wired |
SP-5000, 20W RMS, 90 - 20000Hz, 8 Ohms, 86dB, Silver
Techconnect Ready.
Slide up the grille to reveal a Techconnect modular faceplate. Both speaker chassis have an integrated Techconnect surround and can each accommodate up to 5 modules. Just add Techconnect modules, cables, and a Techmount, and you’ve got all the elements you need to finish an installation.
Accommodates Techconnect Amplifier
Vision’s Techconnect Amp TC2-AMP2 can be clipped into place, or the SP-5000 loudspeakers can be used with any other low-impedance amplifier. If the Techconnect Amplifier is installed the amplifier power supply can be housed in the SP-5000 chassis, or externally if preferred. And of course, the Techconnect Amplifier comes with a remote control for convenience.
Architectural Design
An attractive curved chassis and grille compliment the finish of an interactive whiteboard or flat panel installation.
Audio-Over-USB
The SP-5000 has an integrated circuit which decodes audio received via USB and sends the analogue audio signal to an installed Techconnect Amplifier or an external amplifier. Simply route the USB from the PC to the loudspeakers. The PC will recognise them as an audio output device.
The decoder then has a USB output which routes to the interactive whiteboard. When connecting USB to an interactive whiteboard the decoder must be powered. Power can be shared with a Techconnect Amplifier power supply if installed, or if not the Techconnect Control spare power supply (1872512) is available.
Flexible Cable Routing
If used as a connectivity faceplate cables plugged in to the faceplate can either be routed outward, or can be routed downward so they are hidden behind the grille.
Easy-fit bracket
A simple bracket is provided for attachment to the wall with no fuss. To install just clip the modules into place, plug the cables into the rear, clip the rear cover on, and hang on the brackets.
