Racks Rittal

800 mm x 2000 mm x 800 mm, 1617.00 dm³, 173.90 kg, 42 U, IP20 DK-TS 8 pre-configured network enclosure
DK-TS 8 pre-configured network enclosure, 42 U with two pairs of 482.6 mm (19 inch) mounting angles and side panels.
The symmetrical extrusion frame construction of the network enclosure consists of rolled 16-fold vertical hollow sections with holes on a 25 mm DIN pitch pattern. Integral system punching in the frame section allows simple fitting and securing of equipment according to the plug-and-play technique.
All sections have chamfered edges.
The vertical frame sections have two depth-recessed mounting levels each, that can individually be used for flexible attachment of the installation components or together as basis for a double-walled population, the created interior space can be used, for example, for insulation and climate control purposes.
The horizontal 9-fold sections are provided with an additional protection lip above the seal.

Enclosures are bayable on all sides: on the left, right, front, rear, at the top or round corners.
Glazed designer front door made from extruded aluminium section and 3 mm single-pane safety glass (ESG).
Door opening angle with stand-alone siting 180ТА at least. Including comfort handle for semi cylinder (30/10) mm. Rear door of 2 mm sheet steel, with foamed-in seal, with removable rectangular frame with holes on a 25 mm DIN pitch pattern, locking bar with 4-point latching, swing handle with security lock 3524 E.
Hinges with captive hinge pins.
Door hinging may be swapped from right to left, without dismantling locking rods, door opening angle 130ТА.
Side panels are simply slotted into position, with security lock 3524 E.
482.6 mm (19 inch) attachment level front and rear.
Cranked 482.6 mm (19 inch) mounting angles, screw-fastened on corner brackets at top and bottom of enclosure frame, thus creating optimum cable chamber space.
Distance between levels 500 mm.
Roof plate for cable entry via sliding bracket with rubber cable clamp strip, secured with 4 screws, removable.
1 gland plate at the front, fitted as an infill panel, rear section open.
Even installation turned by 90ТА in the enclosure depth for optional side cable entry is possible due to the symmetrical frame.
100 mm base/plinth with vented trim panels at front and rear, side trim panels solid in RAL 7035.
Earthing of all panels on the enclosure frame, central earthing point at the rear of the base frame.
2 punched sections with mounting flange as shipping brace on inner mounting level.

Supplied loose: 4 levelling feet to compensate for floor irregularities, 4 spacers (20 mm) to raise the roof, 4 cable clamp rails for inner level(may be installed in width and depth), 10 plastic cable shunting rings (105x70 mm), 50 captive nuts M6 (conductive), 50 multi-tooth screws M6 with plastic washers.