Radio receivers Bosch

With its multi-purpose operating modes, the LE10 Radio Receiver can be used in combination with wired Emergency Call or wireless Resident Alert System. It is designed to receive radio signals from different Bosch radio transmitters at the frequency of 434.01 MHz. Upon receiving radio signals from either programmed or not programmed wireless transmitters, the LE10 Radio Receiver reacts by activating its two green and red LED indicators and by switching the relay outputs of its two relays.

Functions
The LE10 Radio Receiver can be set to one out of nine different operating modes in which the device behaves accordingly to different transmitter reception.

Mode 1: Normal
20 wireless transmitters can be programmed. Calls are indicated by LED 2 and Relay 1. A battery-low signal is indicated by LED 2 and Relay 2.

Mode 2: LED 2 deactivated at battery-low indication
Same functions as in mode 1, except the battery-low signal which is indicated only by Relay 2.

Mode 3: Dementia
MIYS37L and MIYS37E wireless transmitters are detected. Relay 1 can be used to lock a monitored door. Relay 2 can be used to interrupt a monitoring loop.

Mode 4: Dementia with Accompany
The LE10 Radio Receiver can be connected to a wired Emergency Call System, in which the Accompany function can be implemented. Here the LE10 Radio Receiver will wait 10 seconds after receiving a signal from a MIYS37L transmitter. If it detects a MIYS37E transmitter in this lapse of time, then no alarm is generated. If not, then Relay 1 is activated for 2 seconds.

Mode 5: Remote control
20 wireless transmitters can be programmed. Per sequence, only the same transmitter can switch on and off Relay 1.

Mode 6: Open receiver
No wireless transmitter needs to be programmed. Any transmitter within reception range of the LE10 Radio Receiver will activate the device.

Mode 7: Open receiver with reduced range
Same functions as in mode 6, with reduced range. This mode improves reception of transmitters located closer to the LE10 Radio Receiver.

Mode 8: Extended MIYN46 transmitter programming(only with SW V1.10)
Additional MIYN46 transmitters can be programmed. Behavior is similar to normal mode 1, with certain differences according to the transmitter that is activated.

Mode 9: Dual channel receiver (only with SW V1.10)
Only MIYS37 transmitters can be programmed. Calls are indicated by Relay 1 or Relay 2, according to the slot where the MIYS37 wireless transmitter is programmed.
A battery low signal is indicated by LED 2.