Here you can compare the prices for remote power controllers AMX, get acquainted with photos and technical characteristics (for example Output alignment, Management software, Input voltage, Ethernet LAN data rates, Current loads per port (max), Current overload protection (max)) and buy a liked model remote power controllers in one of the reliable online stores.
20 A, 110/220 V
OVERVIEW Designed for conduit installation, the Universal Power/Motor Controller, 20 A (110/220 VAC input) is a dual 20-amp AC power and motor controller. Configure a wide range of power and motor control modes for a full range of devices ranging from simple wall panels with low voltage contact closure to large systems requiring high voltage contact closure.
The UPC20+ supports two primary operating modes. In Motor Control Mode, the two relays are automatically activated in sequence with an adjustable delay from 0 to 90 seconds. In this mode, there are three control options: - Single Button Mode operates with one pushbutton in a sequence: Up, Stop, Down, Stop and so on for each successive button press. - Two/Three Button Mode operates with two pushbuttons, one for Up and one for Down and optionally one for stop. - Momentary On/Off operates the first relay only while the button is pressed and then second the relay activates when the button is released.
In Power Control mode, the UPC20+ provides power control for two independent circuits with a combined total load of 20 Amps. In this mode, there are three control options: - Momentary Power Mode operates the selected relay only while the button is pressed. The relay is de-activated when the button is released. - Latching Power Mode toggles between activating and deactivating the selected relay on each successive button press. - Two Button On/Off Mode uses two buttons for each relay, one to activate and one to deactivate.
FEATURES - 1, 2 and 3-button logic modes - Local test switches with status LEDs - 120, 240, and 277 VAC control capability - ETL listed
By clicking on the "Send" button, you agree that your data will be used to process your request. Further information and revocation instructions can be found in the data protection declaration.