Here you can compare the prices for serial cables QVS, get acquainted with photos and technical characteristics (for example Subcategory, Connector 2, Magnetically shielded, Connector contacts plating, ARK ID, Cable shielding) and buy a liked model serial cables in one of the reliable online stores.
DB9, 10ft, 9Pin
All IBM PC and compatible computers are equipped with serial ports for communicating with external devices. A serial port sends and receives data one bit at a time over one wire. While it takes eight times as long to transfer each byte of data this way in comparison to a parallel port, only a few wires are required. Usually, the serial port is "Full-duplex", meaning it can send and receive data simultaneously. This is possible when there are separate lines; one for transmitting and one for receiving. Some devices support only one way communicationand only have two wires - one for transmitting and one for the signal ground.
Two terms that are important to be familiar with are DTE & DCE DTE stands for Data Terminal Equipment, and DCE stands for Data Communications Equipment. These terms are used to indicate the pin-out for the connectors on a device and the direction of the signals on the pins. Your computer is a DTE device, while most other devices are usually DCE devices. DTE & DCE DETERMINATION GUIDE DTE DEVICES Terminals (Gender: Male) DCE DEVICES Modems, CSU/DSU, Multiplexers (Gender: Female) SELECTABLE DTE OR DCE DEVICES Routers, Hubs, Switches, Access Servers (Gender: Either) Selectable devices usually have a jumper, switch, or software command used to select either DTE or DCE.
By clicking on the "Send" button, you agree that your data will be used to process your request. Further information and revocation instructions can be found in the data protection declaration.